Exclusive 2 piece design keeps the weight down so this winch bumper won’t nose dive the front of the truck. 3/16" sub frame/winch plate is attached directly to the front frame rails for the ultimate in strength. Designed for up to a 9500 pound winch, side control box design works best. There is extra room to mount a small air compressor. The otter steel shell mounts up with eight bolts at the shackle points so the entire installation is all bolt on! 11 gauge outer shell provides strength while keeping the weight to a minimum. 4" light pockets will take either after market lights or the OEM fog lights. Additional mounting points for two more lights on top of the bumper. High clearance corners for maximum off road performance. Low center section provides skid plate type protection for the front area of the vehicle.

WARNING: Cancer and Reproductive Harm -  www.P65Warnings.ca.gov .  PRODUCT WARNING/LIABILITY DISCLAIMER:  Aftermarket accessories are intended to modify and/or prepare a vehicle for uses which exceed conditions anticipated by the vehicle manufacturer. These uses include high performance demands and negotiation of rough terrain. These conditions have extreme variance and cannot be controlled by the vehicle manufacturer or aftermarket accessory manufacturer. Therefore, the safe control of your vehicle is entirely your responsibility. Do not purchase parts unless you are willing to accept this responsibility. Do not install any part that you do not feel competent at installing without causing present or future injury to yourself or others; consult a professional installer.  Modification of your vehicle to enhance performance can result is dangerous situations that may result in bodily harm. The buyer hereby assumes all risks associated with any such modifications. The seller will not accept responsibility for personal injury or property damage arising from the failure of any parts.